Home > Interior
Choose a sub category:
Carpet, Sills, Pedals Center Console Convertible
Dash Doors Emblems, Decals
Hardware, Wiring Repair Hatch, Trunk Headliners
Lighting Mirror Rear Seat Deletes
Seat Belts Seats Steering Column
Sun Visors Trim
Sort By:
Page of 20
These two clear tag light lens come with the mounting hardware as well as two white LED bulbs. These LED bulbs are much brighter than the stock incandescent bulbs and will fit directly into the stock sockets with no modifications needed.
Clear tag light lens. Fits 1979-93, all models. Sold separately; 2 required per vehicle. Kit includes 2 door hinge pins, 4 hinge bushings and 2 retaining pins. This kit includes everything to repair one door. Hatch lift supports for 1979-93 hatchbacks. These are the solution for sagging hatch gates or hatches that won't stay up. Sold separately. Two required per vehicle.
Originals are notorious for breaking causing the lid to not latch. These reproductions have the latch reinforced to prevent breaking. This is a set of 14 door panel retaining push pins. One set required per door. This bushing fits on any 1979-93 door lock striker. Save money and replace the bushing instead of the whole striker.
This door lock actuator will fit any 1979-93 Mustang. We also sell the rivet to attach it! These door handle cups come with the rubber seal for the handle. Black in color. Fits 1979-93, all Ford Mustang models. Sold as a set. These rivets are for use with the door lock actuators. One required per actuator.
Nylon plastic bushings that guide the window up and down on the guide rod. Worn out guides cause loose and irregular windows. Fits 1981-93 hatchback and coupe. Please look over guide below to determine which bushing will work for your car! Plastic triangle covers that attach to the interior of the door and cover up the mounting studs for side-view mirror. Sold as a set. Comes with mounting screws. Fits 1987-93, all models.
Kit includes 4 push pins that attach to the back side of the kick panels, 1 large head-short push pin for the passenger side, 1 large head-long push pin for the driver's side and 2 screws. This is a complete kit for 79-93 and replaces both sides. This pad is correct for either the clutch or brake pedal on manual transmission Mustangs. While testing these it was found that the original pedal pad had a loose fitting, so they were improved with a tighter fit.
Lower shift boot goes under the upper shift boot to seal out road noise and heat on the Ford Mustang. Fits manual transmission only.
Repair kit permanantly eliminates a floppy ashtray door. Installation instructions included. Set of 1 ignition key and 1 door/trunk/glove box key blank. These have the Ford oval on one side and "Family of fine cars" on the other side. If your torque pins are bad it will cause your window to only move up and down intermittently even though the window motor is working. This is a common problem for power windows. Easy installation. One kit required per motor.
This is the lock roller and pin that attaches to the lower door hinge. Original pieces sometimes crumble into nothingâ¨â¨. If this part is missing your door will not stay open on its ownâ¨â¨. These Tension check springs are what holds the door open at halfway and all the way open. These are commonly broken and can cause the door to swing shut. This kit attaches at the lower door hinge and is held on by one of the door hinge bolts.
This attaches to the top of the door panel and wipes the inside of the door window as it rolls down. The wipe comes with the chrome strip that is at the top of the door panel. Fits all 1981-93 hard tops. This attaches to the top of the door panel and wipes the inside of the door window as it rolls down. The wipe comes with the chrome strip that is at the top of the door panel. Fits all 1981-93 hard tops.